Filter
Top Products
MERLIN LEGEND Communications System Release 6.1
Installation
555-661-140
Issue 1
August 1998
Connecting the Control Unit to the Network Interface
Page 4-8
Wiring
Figure 4-3. RJ21X Wiring Field Tools
To connect the RJ21X network interface to the control unit, follow the
steps below. Figure 4–3 shows the tools you need.
!For each piece of hardware, drill two diagonally opposite holes into
the backboard, allowing for a 1/16-inch (1.6 mm) space between
each piece of hardware.
!Mount the wire troughs and the termination blocks.
There is a wire trough above and below each termination block.
AT-8762 D
Impact Tool
Spudger
788 K1 Retainer
Tool
110 Impact Tool
788J1
Modular Plug Pressers