Filter
Top Products
MERLIN LEGEND Communications System Release 6.1
Installation
555-661-140
Issue 1
August 1998
Initializing and Testing the System
Page 7-12
Testing the System
!Have the person at the far end place a dial-repeating call to your
telephone by dialing the proper tie-trunk number.
Your telephone rings and the green LED next to ICOM (or SA for
Hybrid/PBX systems) flashes.
!Pick up the handset.
The red LED next to the ringing button turns on and the green LED
changes from flashing to steady.
!Verify that you have good two-way communication and hang up.
The green LED should turn off, the red LED should turn off, and another
red LED may turn on.
!Repeat Steps 1 through 3 for each incoming or two-way
dial-repeating tie trunk.
Testing Outgoing Dial-Repeating Tie Trunks
Perform this test for dial-repeating tie trunks that are two-way or
outgoing only. If you are testing dial-repeating two-way tie trunks,
perform the incoming test as well.
To test outgoing dial-repeating tie trunks, follow the steps below:
!At any telephone that has access to a dial-repeating tie trunk, press
the first tie-trunk button.
The red LED next to the pressed tie-trunk button lights.
!Pick up the handset. (In Hybrid/PBX systems with pooled tie trunks,
press an SA button and dial the pool dial-out code.)
The green LED next to the selected button lights.
!Dial the tie-trunk number of the extension where someone is
waiting for your call.
You should hear ringing.