Filter
Top Products
MERLIN LEGEND Communications System Release 6.1
Installation
555-661-140
Issue 1
August 1998
Initializing and Testing the System
Page 7-6
Testing the System
!Connect a working 2500-type single-line telephone with a Message
light to the MFM adapter (the 2500 telephone also must have a
mechanical ringer).
!Pick up the handset and listen for dial tone. Dial
.
You should hear another dial tone.
!Press any button.
This will deactivate the test tone.
!Dial
.
Press the switchhook quickly.
You should hear a confirmation tone.
!Hang up.
The control unit should send a ring burst and the Message light on the
2500 telephone should turn on.
!Turn off the Message light.
Dial the appropriate feature code.
Testing Telephones for Dial Tone
To test for dial tone, follow the steps below:
!Press an ICOM or SA button (depending on the mode of operation).
The red LED next to this button should go on.
!Press the Speaker button.
The green LED next to ICOM or SA button should turn on; you should
hear a dial tone, and the green LED next to the Speaker button should
turn on.
!Press the Speaker or ICOM or SA button again to disconnect
intercom.
The green LEDs next to ICOM or SA and Speaker buttons should turn off
and the dial tone should stop. The red LED remains on in some cases.