Filter
Top Products
Mitel NuPoint Messenger Technical Documentation - Release 7.0
optional features. For more information about any of them, contact your distributor.
• BBL Pager
• Hyatt Encore PMS Integration
• PMS Integration
• HIS PMS Integration
• Hitachi PMS Integration
• Hitachi DX
• ITT
Programmable Interface
The Programmable option allows you to customize the RS-232 message indicator software
interface between the server and the PBX. All codes are sent in ASCII. Numbers, letters, and
certain special characters (Table 5-3) are understood by the software.
Configuring a Pre-Programmed RS-232 Interface
Configuring any of these interfaces consists of defining a serial port then making selections from
the respective interface menu. See "Message Waiting Indicators" in the task list for configuration
procedures.
Use the RS-232 Message Waiting Lights Worksheet (Figure 5-2) to organize the information you
need for configuring one of these interfaces. If the interface is an optional feature, also contact
your local distributor for additional directions. A blank worksheet is located in Volume 2 of this
Manual.
Configuring the Programmable Interface
The RS-232 Message Waiting Lights Worksheet (Figure 5-2) organizes the information that is
necessary for configuring the programmable interface. You can use ASCII codes in any of the
strings described in the following paragraphs.
Table 5-3 lists the valid ASCII codes that can be used. The following descriptions can help you to
complete this worksheet.
Initialization String
This string is sent to the PBX to notify it that the server is ready to send message waiting indicator
requests.
Reply String
After the initialization string is sent, the server waits for the PBX to return this reply string, before
sending message indicators requests.
Pre-DN On String
This string is sent before the directory number (extension number) to instruct the PBX to turn the
message waiting indicator on at that station.
Pre-DN Off String
©
Copyright 2002, Mitel Networks Corporation 73