Filter
Top Products
Mitel NuPoint Messenger Technical Documentation - Release 7.0
Wait for a dial tone, to confirm that you have the outside line. T
Dial the number of the pharmacy branch. 12135556598
To send the message, the pharmacy headquarters makes the message and sends it to a
distribution list that contains all the pharmacies’ numbers. This list is created either at the server
maintenance console or by the user at a telephone (see the Distribution Lists chapter). If the
dialing plan is set to make 8 the call placement digit (for example, 3,3,3,3,3,3,3,T,3), the
distribution list looks like this:
Distribution List: 01
Members:
T12135556598
T12135551434
T12135557969
etc.
This sends the message to each phone number in the list.
To add call placement to a mailbox, specify the pager system in the appropriate outdial index
prompt, then respond to the call placement pager access type prompt as follows:
Billed outdial index or unbilled outdial index 1 (A pager system set to T9T)
Call Placement access type B or U
Testing the Configuration
After telephone lines have been installed, and after you create mailboxes for a Pager application,
test each mailbox.
Note: It is very important to test a pager immediately after it is added to a mailbox, since a seemingly
minor error in configuration can cause every page to fail. Furthermore, the server can tie up pager
ports for a long time dialing invalid paging codes.
Testing Paging
Before performing individual test steps, configure the Event Recorder and enable it. After testing
is completed, disable the Event Recorder. For detailed instructions about the Event Recorder,
see the
NuPoint Messenger Installation and Service Manual.
Briefly, you test paging by leaving a message in the mailbox, then contacting the user to be sure
that the page was successful. You can use the Lights Test option from the server maintenance
console to test each display or tone pager mailbox. See the task list for procedures, Volume 2 of
this manual.
Testing Alternate Pager Activation
If you have configured an alternate pager, it is activated after the frequency and interval of the
primary pager have expired, but before the message has been played. After testing the primary
pager, repeat the test for the alternate pager dial strings. (See the task list for procedures,
Volume 2 of this manual.)
©
Copyright 2002, Mitel Networks Corporation 61