Filter
Top Products
Mitel NuPoint Messenger Technical Documentation - Release 7.0
Primary Pager 1 Pager 3
Alternate Pager 2 Pager 4
Paging and Message Delivery in the Same Mailbox
You cannot assign both paging and message delivery to the same Message Waiting Indicator. If
you want to assign both Paging and Message Delivery to the same mailbox, be sure each has a
different indicator. You can use any of the four different indicators: MWI1 primary, MWI1
alternate, MWI2 primary, MWI2 alternate to accomplish this.
Other Mailbox Parameters
Other Pager application parameters that you can set in the mailbox configuration are listed below.
Pager interval
This is the length of time (0-255 minutes) the server waits between pages. The default is 30 (wait
half an hour between pages).
Busy pager attempts
This is the number of times (0-255) the server retries the page until it completes the specified
number of pages or completes a successful page. Set the number of attempts to a high number if
the server will be encountering busy pager systems.
The default is 0, unlimited retries.
Busy pager interval
This is the length of time (0-255 minutes) the server waits between pages when a busy signal has
been received. Set the Busy Pager Interval lower than the Pager Interval setting. The idea is that
if a busy signal has been received, the page should be retried sooner than if speech or silence
was received.
The default is 0, retry every minute.
Message delivery
This activates the message delivery option of paging. When enabled (set to Y), a new message
causes the server to call the telephone number defined for message delivery, and ask whomever
answers to log into the user’s mailbox. Then the user can hear the message and perform other
NuPoint Voice operations.
If message delivery is enabled, paging is not available for that message waiting type. However,
you can set one message waiting type can for paging and another for message delivery. Or, on
the same message waiting type, you can set the primary for paging and the alternate for
message delivery.
The default is N, no message delivery.
Suppress pages
This parameter turns off the paging feature without removing all the settings. Use this option to
temporarily remove the paging option from a mailbox.
©
Copyright 2002, Mitel Networks Corporation 49