Filter
Top Products
Mitel NuPoint Messenger Technical Documentation - Release 7.0
Enter Y or N; Y to suppress pages. The default is N, do not suppress pages. Set this field to N to
resume the paging option after turning it off.
Pager start time
This is the time that the server starts sending pages for this mailbox. By setting both start and
stop time to 12:00 a.m., paging is available 24 hours.
Enter the time in the form “hh:mm xm”, where “hh” is hours, “mm” is minutes, and “xm” is either
a.m. or p.m. The default is 12:00 a.m.
Pager stop time
This works with Pager start time, above, and is the time the server stops sending pages for this
mailbox. The default is 12:00 a.m.
Paging Considerations
This section covers specifics applicable only to paging.
Changes by the Server Administrator
You can alter the following mailbox information to use paging:
• FCOS
• LCOS
• Pager number
• Post-pager number
Changes by Mailbox Owners
From a pushbutton telephone, mailbox owners can modify the following parameters:
• Telephone number to send pages
• Time at which the server starts paging
• Time at which the server stops paging
To allow mailbox owners to reset these parameters, you might need to modify the mailbox
owners’ mailbox configuration:
• An FCOS that includes feature bit 070, and either 077 or 124 or both
• The LCOS that sets limits for the length of paging phone numbers
• The post-pager number
Feature Bits Used in Paging Mailboxes
Feature bits listed in Table 4-2 control paging. Two that deserve special mention affect changes
to the weekday/weekend schedule and pager re-queuing.
Change Weekday/Weekend Schedule
With one exception users of any Pager application can set schedules for weekdays or weekends,
showing when they can be reached. The exception is that when NP TDD is enabled, call
scheduling is not available.
©
Copyright 2002, Mitel Networks Corporation 50