Filter
Top Products
Mitel NuPoint Messenger Technical Documentation - Release 7.0
Automatic Wakeups or TAS messages:
Receipt requests:
Disk Usage:
Network Messages Sent:
Network Urgent Messages Sent:
Network Messages Received:
Network Urgent Messages Received:
Number of Network Nodes Sent to:
Number of Network Nodes Sent Urgent:
Number of Remote Network Recipients:
Number of Remote Network Recips Urg:
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0
0
0
0
0
0
0
0
0
0
0
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
F1 Nxt Pg F2 Prev Pg F3 First F4 Last F9 Cancel F10 Save Home Help
Enter low usage rate,(0-64.999), with a max of 3 places after decimal.
A D J U S T B I L L I N G R A T E S
Page 7
Rate
Low Usage
Boundary
High Usage
Pager Number 4 Rate:
Pager Number 5 Rate:
Pager Number 6 Rate:
Pager Number 7 Rate:
Pager Number 8 Rate:
Pager Number 9 Rate:
Pager Number 10 Rate
Pager Number 11 Rate
Pager Number 12 Rate
Pager Number 13 Rate
Pager Number 14 Rate
Pager Number 15 Rate
Pager Number 16 Rate
Base Rate 1: UNLIMITED
Base Rate 2: FULL GUEST
Base Rate 3: RESTRICTED
Base Rate 4: CHECK IN
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.00
0.00
0.00
0
0
0
0
0
0
0
0
0
0
0
0
0
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
0.000
F1 Nxt Pg F2 Prev Pg F3 First F4 Last F9 Cancel F10 Save Home Help
Enter low usage rate,(0-64.999), with a max of 3 places after decimal.
Figure 11-1 Full Screen Interface for Billing Rates
Scrolling Menu Interface
If you are using Scrolling Menus, then Billing Rates are set through several different menus,
depending on the type of rate. The Billing Worksheet, described later in this chapter, is divided
into sections that correspond with the separate menu choices. Some of the rates belong in other
menus, because the full-screen Adjust Billing Rate entry screens are arranged differently. These
items are indicated by having the correct section name following the rate name in parentheses.
Gathering Data
Before the server can produce billing reports, it must gather data from all the statistics that have
been specified. Gathering data is a three-step process:
1. The current billing data file, which was created during the last gather, becomes the new
previous billing data file. The server issues a warning because this step overwrites (and
thereby destroys) the previous billing data file, which was also created during the last gather.
2. The server scans the statistics in all the mailboxes. The data that is collected becomes the
new current billing data file.
©
Copyright 2002, Mitel Networks Corporation 148