Filter
Top Products
Mitel NuPoint Messenger Technical Documentation - Release 7.0
(defined in one of the 16 pager systems), the pager number and the post-pager number. The
access code contains the part of the dial string that is stored in the online configuration. The
pager number and post-pager number are the parts of the dial string that are stored in an
individual user’s mailbox configuration. Assign dial strings to each section using the following
structure:
• The access code, identified by the pager system index number, contains the first part of the
dial string necessary to reach the user’s pager. It is usually the part of the dial string that is
common to some group of users.
• The pager number is the balance of the dial string necessary to reach the user’s pager.
• The post-pager number is used as the data to display on a display pager.
Note: If there is no pager or post pager dial string entered, a page will not be sent.
Table 4-1 Pager Dial String Characters
Character Explanation
0-9, *, # Keys on a standard pushbutton telephone
( The following digits should be dial pulsed (10 PPS)
) Stop pulsing; resume sending DTMF tones
+ Pause for one second
A-D Fourth column DTMF keys
E Go off-hook, wait for dial tone or other steady tone (pager go- ahead or
confirmation tone, for example), then do next item in string
F Switch hook flash followed immediately by dialing
G Greet - Wait for a voice or computer tone answer
H Hang up (go on-hook)
L Answer Supervision - Wait for telephony signal from destination. Use only
with trunk (four-wire) connections.
N Start a new activity; do not go off-hook
O Ring once
P Go off-hook, do not wait for dial tone
S Switch hook flash, no wait required
T Go off-hook, wait for dial tone
V Voice pager: play first unplayed message (and update mailbox to count it as
played)
When designing your dial strings, observe the following rules in assigning each of the three
components:
• The first character in the dial string must make the server go off-hook and wait for a dial tone.
A T is recommended.
• An F (switch hook flash) produces the switch hook flash followed immediately by dialing
• The access code is always outdialed before the pager number. The dial string used is
dependent on the pager system selected.
• The pager system part of the dial string is limited to 30 characters.
• Only 16 pager systems can be stored in the NuPoint Voice configuration at any one time,
regardless of the number of paging groups configured. However, each pager system can be
shared by many users or line groups.
©
Copyright 2002, Mitel Networks Corporation 44