Filter
Top Products
Mitel NuPoint Messenger Technical Documentation - Release 7.0
as a printer.
Using the Logfile Menu, there are two ways to change where the logfile is viewed and what port it
is sent to. The menu choice “Toggle Display, Choose Logfile Serial Redirection,” changes where
the information is sent as it occurs. This is a temporary setting and is removed when the server is
reset. You can use this menu option when the hard disk has run out of room to save the log data,
or if you want to see the log activity momentarily. The menu choice “Choose logfile serial
redirection,” changes the default settings and is used after a server reset. By changing the serial
redirection to a serial port that has a printer attached, you can produce a hard copy of the
information. You can still view the report on the console using the “Show logfile” menu option.
For server maintenance, review and clear all logfiles on a weekly basis. If entries have been
made to the report since the last time it was displayed, the System Status screen above the Main
Menu shows a Y in the ERRORS: field.
Note: If you are unsure of the meaning or importance of any logfile message, do not clear the logfile until
you have consulted with the server technician or your distributor.
The logfile is in the format:
<sitecode><m> <tid>(<task_name>) <date> <time>: <error message> <code>
where:
<sitecode> Site code assigned to the module (seen serial output only)
<m> Module on which the failure occurred
<tid> Task id of the program reporting the problem
<task_name> Name of the server resource
<date> Date of the occurrence
<time> Time at which this happened
<error message> Type of error that has occurred
<code> Failure code
If your server is single module, the module number is listed as 0 instead of 1.
Failure codes are explained in the
Installation and Service Manual.
A Sample Logfile Report from
a single module server is shown in Figure 12-1.
Figure 12-1 Sample Logfile Report
SYSTEM ERROR LOGFILE
Thu Apr 20 17:34:39 1995
1 00151(vmnet ) 04/20 16:37:05: VMNET: NB1 skip 0 [90100000002640]
1 00151(vmnet ) 04/20 16:37:05: VMNET: set_nq_rply(4) skip 0
[90100000002640]
1 00142(vmnet ) 04/20 16:39:35: VMNET: NB1 skip 0 [90100000002640]
1 00142(vmnet ) 04/20 16:39:35: VMNET: set_nq_rply(4) skip 0
[90100000002640]
1 00115(netq_age) 04/20 16:39:35: NETQLIB: can't send to NETQ
1 00296(allocato) 04/20 16:39:35: allocator: Allocated
'/usr/vm/bin/netq' to node 1 type 5
1 00105(sendvm ) 04/20 16:39:36: aopen fail reslt=-
©
Copyright 2002, Mitel Networks Corporation 157