Filter
Top Products
Chapter 3 ( SRS-2100 Local Features
Page 3-29
Message logging works in two
modes:
• The Logging mode, which
stores messages in a history
file without displaying them
• The History mode, which
displays messages stored in
the history file. The history file
can hold up to 24 messages at
a time.
This section covers the
procedures to:
• Start and stop message
logging
• Review logged messages
Note: When you stop message
logging, all messages stored in
the history file are saved and
can be reviewed at a later time.
Appendix F provides the System
Administrator or service
technician with information useful
in decoding messages. (Because
of the limited space on your
display, messages appear as a set
of codes and abbreviations.)
Starting or Stopping Message
Logging
You go through the same
sequence of menus to start or
stop message logging.
1. Press REGISTER (softkey 4), 9,
ENTER (softkey 1).
The following screen appears:
MESSAGE LOGGING - SELECT ITEM (1-
3)
1: LOGGING-START 2: LOGGING-STOP
3: HISTORY MODE
ENTER NEXT CLEAR
REGISTER
2. Make your selection.
To start message logging, press 1,
then press ENTER.
The message MESSAGE
LOGGING START SELECTED
appears.
To stop message logging, press 2,
then press ENTER.
The message MESSAGE
LOGGING STOP SELECTED
appears.
3. To return to normal operations,
press REGISTER.
The standard display screen
reappears.
Reviewing Logged Messages
To review messages in History
mode, complete the following
steps:
1. Press REGISTER (softkey 4), 9,
ENTER (softkey 1). This screen
appears: