Filter
Top Products
Chapter 2 ( SRS-2100 Voice Features
Page 2-5
If you are not talking on
another call
1. Press the SPEAKER button. Its
LED will light red and you will
hear a dial tone (if not, press an
idle Call Appearance). If this
connects you with a ringing call,
follow the procedure "If you are
already talking on another call".
2. Dial the desired number by
pressing the keys on the
numeric keypad.
3. If your call is not answered,
press SPEAKER to hang up.
4. If your call is answered,
converse with the called party.
(If the MIC-OFF LED is red, the
microphone has been turned off.
Press MIC-OFF to turn it back
on.)
You can turn off the microphone
by pressing the MIC-OFF button;
its LED will turn red. No sound
will then be transmitted to the
called party, allowing you to hold
a private conversation with others
in the room. To turn the
microphone back on, press MIC-
OFF again; its red LED will go
dark.
5. When the conversation is over,
hang up by pressing the
SPEAKER key. Note the call
duration vanishes after about
three seconds.
or
Press DROP. (5ESS
Note: Onhook dialing. In place
of steps 1 and 2, you can dial
the number first and then press
SPEAKER. The phone
automatically dials the number.
The number you enter remains
available for dialing for about
three minutes.
You can also use a one-touch
button, which automatically
selects handsfree operation on
an idle CA and dials the number.
Steps 1 and 2 are therefore
unnecessary when you use a
one-touch button.
(See also "Handsfree, Handset,
and Headset Modes", in Chapter
3, "Local Features".)
If you are already talking on
another call
1. Handle the active call in one of
the following ways:
a. End the call by pressing
SPEAKER. Press SPEAKER
again to get a dial tone.
or
b. Retain the call by pressing an
idle Call Appearance button,
which gives you a dial tone.
(The call is automatically put
on hold.) "Continued"