Filter
Top Products
SRS-2100 Testing ( Appendix C
Page C-4
Any error code display reflects an
error condition to be handled by
your System Administrator.
No other test requests are allowed
during this test. If any error is
detected, the test sequence stops
at that point and reports by
displaying an error code.
When the RAM test terminates
successfully, the Digital Set goes
immediately to the ROM access
test. Upon detection of an error,
the sequence stops and an error
code is displayed.
When the ROM access test
terminates successfully, the DTE
interface circuit test starts
automatically on sets that have
the optional data terminal adapter.
An error in this test is reported by
an error code in the LCD display.
When the DTE test terminates
successfully, the NT line test
starts automatically. An error in
this test is reported by an error
code in the LCD display.
If all tests terminate successfully,
the following display shows on
the LCD:
SELF TEST (MEMORY/LINE)
VOICE & DATA ALL GOOD
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . .