Filter
Top Products
Chapter 4 ( SRS-2100 Data Operation
Page 4-1
CHAPTER 4
DATA OPERATION
The SRS-2100 Digital Set with a
Terminal Adapter allows you to
use the set for data applications.
Please refer to the Fujitsu Data
User's Guide for information on
how to set up and configure the
Terminal Adapter for proper
operation.
UNA-LIST DATA CLEAR DIR-LIST
1 2 3 4
5:20 PM Tuesday January 4
Service
Standard Softkey Layout
(The DATA softkey label appears
only if you have a voice/data
terminal.)
Note: Softkey 1 also serves as
the ENTER key (for entering
information as indicated in this
User's Guide).
USING THE TERMINAL
ADAPTER
This chapter describes three ways
to make a data call using the
integrated Terminal Adapter (TA)
in your Digital Set.
• Using the DATA softkey
(second button from the left
under the display)
• Using AT commands at your
terminal
• Using the X.28 commands at
your terminal
There are three LEDs below the
multifunction buttons of the SRS-
2100. DTR (Data Terminal Ready)
must be steady green to establish
a connection.
Transmitting data from your
terminal causes the TXD
(Transmit Data) LED to flash, and
receiving data causes the RXD
(Receive Data) LED to flash.
MAKING AND TERMINATING
A DATA CALL
You can start or end a data call
either manually or by using
commands at your terminal, as
described in the following
sections.
Using the DATA Key
To make a data call using the
digital set DATA key, use the
following steps: