Filter
Top Products
SRS-2100 Local Features ( Chapter 3
Page 3-6
ENTER DIRECTORY NUMBER (12)
8247629,99,,2502
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . .
ENTER NEXT CLEAR
REGISTER
Note: If you try to exceed the 30-
digit limit, the set refuses the
input and the display remains
unchanged.
4. Press ENTER (softkey 1). The
associated LED turns green, and
the word COMPLETED appears,
remaining for 15 seconds:
ENTER DIRECTORY NUMBER (12)
942229876543
COMPLETED
ENTER NEXT CLEAR
REGISTER
5. Complete the procedure in one
of these ways:
To return to the normal display,
press REGISTER (softkey 4).
To program another one-touch
number, press an unassigned
multifunction button. (You can
also press a currently assigned
one-touch button to change or
cancel its one-touch number.)
To return to the Service Mode
main menu, press asterisk (*).
Correcting Mistakes
How you correct a mistake
depends on where you are in the
programming procedure:
• Before pressing ENTER - to
record the number, press
CLEAR (softkey 3) to erase the
number. Then enter the correct
number.
• After pressing ENTER - if the
number on the COMPLETED
screen is incorrect, press the
multifunction button again.
The ENTER DIRECTORY
NUMBER screen appears
showing the incorrect number.
Enter the correct number and
then press ENTER. The correct
number appears on the display
as you enter it and replaces the
incorrect number.
Changing or Canceling the
Number Stored in a One-
Touch Button
To change or cancel the one-
touch number currently stored on
a one-touch button, follow these
steps:
1. Press SERVICE, then REGISTER
(softkey 4), 1, ENTER (softkey
1). This screen appears:
ONE-TOUCH
SELECT ASSIGN KEY
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . .