Filter
Top Products
SRS-2100 Voice Features ( Chapter 2
Page 2-16
Warning: Pressing DROP at the
end of a conference call drops
both participants.
Using DROP on a Conference
Call
Press the DROP button. This
ends your connection with the
last party you added to the call,
but any others on the call stay
connected. If only two parties
remain, the call is disconnected.
The display of the call's duration
continues until the call is over.
TRANSFER (5ESS
Transfers a call to another
phone and announces the
transfer privately
To transfer a call, follow these
steps:
1. Press TRANSFER while on an
active call.
The LED of the Call Appearance
in use flashes red; the called or
calling party is automatically
placed on hold.
An idle Call Appearance is
selected. Its LED lights steady
red and a dial tone sounds.
If that directory number has no
idle Call Appearance, you must
select a Call Appearance of
another directory number.
2. Dial the third party.
3. Once connected, announce the
transfer to the person who
answers and converse privately.
4. Press TRANSFER again, and
hang up.
The third party, just called, is
connected to the party held for
transfer. You are dropped from
the call, and the other two
parties remain connected.
Note: A "blind" transfer is where
you do not talk to the person
you are transferring the call to.
To perform a blind transfer, wait
for the person's phone to ring,
press the TRANSFER key, and
hang up.
Questions, Details, or
Alternatives
If no one answers the destination
number, hang up. Press the
SPEAKER button, the Switch
Hook, or, with a Lucent switch,
press DROP. Then press the Call
Appearance holding the original
call. This cancels the attempted
transfer and returns you to the
call.