Filter
Top Products
Chapter 3 ( SRS-2100 Local Features
Page 3-3
2. To select the option you want,
press the appropriate key(s) on
the numeric keypad to dial 1 to
13 (do not press one of the four
buttons under the screen) and
then press ENTER (softkey 1).
If you notice a mistake after
pressing ENTER and want to
cancel the keypad entry, press
asterisk (*). To clear an entry
before pressing ENTER, press
CLEAR (softkey 3).
3. To exit Service Mode, press
REGISTER (softkey 4). If you
forget to exit, Service Mode is
automatically canceled after four
minutes, or whenever you pick
up the handset or press
SPEAKER.
Whenever REGISTER is pressed,
it either enters or exits Service
Mode, no matter what else may be
in progress.
Note: If you enter Service Mode
during a call, special features
such as Call Pickup and Call
Forwarding are temporarily
disabled. However, regular
calling controls such as HOLD,
SPEAKER, MIC-OFF, and call
disconnection remain available.
Once you are familiar with the
menu choice numbers, you can
go directly to the one you want
after pressing REGISTER. For
example, you can abbreviate the
key sequence REGISTER NEXT
7 ENTER to REGISTER 7
ENTER, getting to the RINGER
screen without displaying the
other menus shown in this
section.
Notes on Entering
Information
When the displayed entry is
acceptable, press ENTER to retain
it and display the next parameter
screen.
To change a numerical entry
before you press ENTER, press
CLEAR (softkey 3) and enter the
desired value.
To change a menu selection or a
numerical entry after you press
ENTER, press asterisk (*). In
some cases, this returns you to
the preceding data entry screen,
where you can enter the correct
information. In other cases, you
return to the Service Mode main
menu and must redo the
procedure from there.
PROGRAMMING A BUTTON
FOR ONE-TOUCH DIALING