Filter
Top Products
Appendix B ( SRS-2100 Installation
Page B-15
1. Press 1 and ENTER. This screen
appears:
CALL APPEARANCE REGISTRATION
SELECT ASSIGN KEY
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . .
ENTER NEXT CLEAR
REGISTER
The first button lower left, lights
green. This is the factory default
CA=1.
2. Press button 1.
3. Press CLEAR (softkey 3),
ENTER (softkey 1). The green
call button will extinguish.
This screen appears:
CALL APPEARANCE REGISTRATION
CA=
COMPLETED
ENTER NEXT CLEAR
REGISTER
Now that you have cleared CA=1
from your first call button, you are
ready to program Directory
Numbers.
If COMPLETED still appears on
the display, press keypad *, 10,
ENTER (softkey 1), 3, ENTER.
The set's indicators show button
status as follows:
• Green indicates a button
already assigned to a
Directory Number.
• Red indicates a button already
assigned to a network feature
or to a local feature such as
one-touch.
• Unlit indicates an unassigned
button.
4. Press the button to which you
want to assign the Directory
Number.
You can press any unlit or green
multifunction button. If you
press a red button, the display
shows the message INVALID
SELECTION and the set waits for
you to press a valid button.
• If you press a green button,
the display shows the current
Directory Number assigned to
that multifunction button.
You can either enter a new
Directory Number to replace
the current number or cancel
the current number.
• If you press an unlit button,
the screen looks like this:
DIRECTORY NUMBER MODE
DN= (XX)
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . .
ENTER NEXT CLEAR
REGISTER