Filter
Top Products
SRS-2100 Installation ( Appendix B
Page B-16
XX is the number of the
multifunction button you pressed.
If you pressed a green-lit button,
the current Directory Number
appears after DN=. The new
number you enter replaces this
number.
5. You now have two choices:
• To add or change the DN
assignment, enter the
Directory Number and then
press ENTER.
• To cancel a DN assignment,
press CLEAR (softkey 3) and
then press ENTER.
The final screen looks like this:
DN=XXXXXXX (XX)
COMPLETED
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . .
ENTER NEXT CLEAR
REGISTER
If you canceled the current
assignment, no numbers appear
after DN= and the button
indicator goes dark.
Note: If you are assigning
multifunction button 1, you
must enter the set's primary
Directory Number.
6. With your Directory Number
assignment complete, you have
these choices:
• To assign another DN button,
press the desired button and
repeat steps 4 and 5.
• To return to normal operation,
press REGISTER.
• To make additional button
assignments, press any red-lit
button and then press asterisk
(*). This returns you to the
menu mode main menu.
This completes the programming
of Directory Numbers. If you
have programmed your SPID
correctly, completed this
procedure, and your ISDN line is
properly plugged in, you should
now be ready to place and receive
voice calls. If you encounter
problems, review these
procedures for accuracy.
Selection 4: Intercom/Group
Intercom
Press 4 and ENTER. This screen
appears:
ICM/GIC MODE
SELECT ASSIGN KEY
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . .
ENTER NEXT CLEAR
REGISTER