Filter
Top Products
SRS-2100 Installation ( Appendix B
Page B-24
For use with the printing
application, Fujitsu has included
two laser printer compatible paper
template with the SRS-2100 User’s
Guide. As an alternative, you
may print, type, or write in the
needed designation on the
template. Additional templates
may be purchased from your
distributor or from Fujitsu.
Do not separate the two 2100
templates or remove the margin
material before printing.
All other loose materials must be
removed before placing the
template in the laser printer.
Failure to remove loose materials
may result in a paper jam in the
printer. Templates are fed via the
manual feed tray.
Please address questions about
the program to FNC TAC, at 1-
800-228-ISDN.
Fujitsu Terminal Equipment
Termination Resistors (TR)
Fujitsu ISDN phones have a
Terminating Resistor (TR) switch
on the back of the set. The
options are ON and OFF.
Fujitsu TR's are equivalent to 100
Ohms in the ON position. Refer
to the following discussions for
TR setting recommendations.
NT1 Settings
Termination
Many NT1's have settings
available to turn Termination ON
or OFF. If the setting is ON they
may also have settings to select
either 50 or 100 Ohms.
Sometimes these settings are
accomplished via switches, other
times they are done with jumpers.
Follow the NT1 manufacturer
instructions to set the
Termination to ON or OFF as
needed.
Timing
NT1's also have a timing setting
with the options FIXED or
ADAPTIVE. On some NT1's the
options may be labeled PB or
PTP. PB is equivalent to FIXED
and PTP is equivalent to
ADAPTIVE. Timing settings in
the following discussions are
based on NT1 manufacturer
recommendations.
Single Unit Installations