Filter
Top Products
SRS-2100 Local Features ( Chapter 3
Page 3-2
Note: The procedures to set local
features require extensive use of
the softkeys located below the
display.
Some of the data entry screens in
Service Mode procedures have
built-in timers. If you do not enter
information within 15 seconds,
the display reverts back to the
menu for selecting the feature you
were using. You must reselect the
feature and start over.
If for any reason you become
confused while working in Service
Mode, you can always press
REGISTER (softkey 4) to return to
the menu selections and start
over.
Selecting a Menu Option
You can display and choose
among the thirteen menu options
at any time, as follows:
1. Press SERVICE, then REGISTER
(softkey 4) to display the menu
options. The screen looks like
this:
SELECT ITEM (1-13)
1: ONE-TOUCH 2: CALENDAR/CLOCK
3: INITIAL 4: UNA-LIST SERVICE
MODE
ENTER NEXT CLEAR
REGISTER
To see the next menu screen,
press NEXT (softkey 2):
SELECT ITEM (1-13)
5: HANDS-FREE MODE 6: HAND-
SET/HEAD-SET
7: RINGER MODE 8: SPID/TEI ASSIGN
ENTER NEXT CLEAR
REGISTER
Press NEXT again to see the third
menu:
SELECT ITEM (1-13)
9: MESSAGE LOGGING 10: KEY
ATTRIBUTE
11: INTERCOM FEATURE 12: MIC MUTE
MODE
ENTER NEXT CLEAR
REGISTER
Press NEXT again to see the
fourth and final menu:
SELECT ITEM (1-13)
13: PREFERENCE MODE
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . .
ENTER NEXT CLEAR
REGISTER
Press NEXT repeatedly to cycle
through these four menus.