Filter
Top Products
2-19
Cisco Wireless IP Phone 7920 Administration Guide for Cisco CallManager Release 3.3 or Later
OL-3930-02
Chapter 2 Preparing to Install the Cisco Wireless IP Phone 7920 on Your Wireless Network
Adding Phones to the Cisco CallManager Database
After you have collected MAC addresses, choose Device > Add a New Device in
Cisco CallManager Administration to begin.
For additional instructions and conceptual information about Cisco CallManager,
refer to Cisco CallManager Administration Guide and to Cisco CallManager
System Guide.
Related Topics
• Determining the MAC Address of a Cisco IP Phone, page 2-13
• Adding Phones with Auto-Registration, page 2-16
• Adding Phones with Auto-Registration and TAPS, page 2-18
• Adding Phones with BAT, page 2-19
Adding Phones with BAT
The Cisco Bulk Administration Tool (BAT) is a plug-in application for
Cisco CallManager that enables you to perform batch operations, including
registration, on multiple phones.
To add phones using BAT only (not in conjunction with TAPS), you first need to
obtain the appropriate MAC address for each phone. See the “Determining the
MAC Address of a Cisco IP Phone” section on page 2-13 for instructions.
Note When using BAT to add Cisco Wireless IP Phones, use the default setting for the
phone load. The phone load name includes symbols (-, _, .) and BAT does not
permit symbols in an entry.
For detailed instructions about using BAT, refer to Cisco CallManager
Administration Guide and to Bulk Administration Tool Guide for
Cisco CallManager.
Related Topics
• Determining the MAC Address of a Cisco IP Phone, page 2-13
• Adding Phones with Auto-Registration, page 2-16
• Adding Phones with Auto-Registration and TAPS, page 2-18
• Adding Phones with Cisco CallManager Administration, page 2-18