Filter
Top Products
5-9
Cisco Wireless IP Phone 7920 Administration Guide for Cisco CallManager Release 3.3 or Later
OL-3930-02
Chapter 5 Configuring Network Settings on the Cisco Wireless IP Phone 7920
Verifying or Entering Network Settings
A check mark appears next to the Disable option.
You must manually set the network settings in the Static Settings menu. See the
“Configuring Static Settings” section on page 5-9 for more information.
Related Topics
• Enabling DHCP, page 5-8
• Configuring Static Settings, page 5-9
Configuring Static Settings
When DHCP is disabled in the network, you must configure the following settings
in the Static Settings menu:
Use these guidelines when manually configuring the IP settings:
• Ensure the TFTP server has an IP address.
• Ensure the default gateway IP address is on the same subnet as the host IP
address.
Note Procedures involved in configuring IP settings or TFTP options cannot be
completed when DHCP is enabled in your network.
This section covers the following topics:
• Assigning an IP Address, page 5-9
• Assigning a Subnet Mask, page 5-10
• Assigning a Primary Gateway, page 5-11
• Assigning a Primary TFTP Server, page 5-11
• Assigning DNS Servers, page 5-12
Assigning an IP Address
The IP address is the unique logical address identifying each host computer, or
node, on a TCP/IP network. An IP address is a 32-bit number expressed as four
decimal numbers from 0 to 255 separated by periods.