Filter
Top Products
6-17
Cisco Wireless IP Phone 7920 Administration Guide for Cisco CallManager Release 3.3 or Later
OL-3930-02
Chapter 6 Configuring the Wireless Network Settings on the Cisco Wireless IP Phone 7920
Performing a Site Survey Verification
The display provides the following information about the APs.
Step 5 To see more information about an AP, scroll to the desired line and press Detail.
The following information appears for the specific AP.
SSID: abcd1234
Channel:6 (C)
RSSI:51 CU:0
MAC:000a11b22c33444 (C)
Note The complete SSID and the MAC address are provided. When two or
more APs are on the same connected channel, the (C) next to the MAC
address indicates that the phone is connected to this AP.
Step 6 To verify the ability to roam between APs, walk through all areas where phones
will be used and take readings. Approach areas from different directions to assure
successful roaming conditions.
Step 7 Adjust AP and antenna placement and AP power settings to meet the ideal
wireless voice environment as described in Requirements for an Optimal Wireless
Voice Environment, page 6-18.
In addition to the Cisco Wireless IP Phone 7920 site survey utility, you can also
use the Cisco Aironet Client Utility Site Survey Utility from a laptop PC. Refer
to the section on “Performing a Site Survey” in the Cisco Aironet Wireless LAN
Client Adapters Installation and Configuration Guide for your system.
Related Topic
• Site Survey Verification Steps, page 6-15
AP
Channel Channel State SSID
Received Signal
Strength
Indication (RSSI)
Channel
Utilization
Connect
AP
1 Active (A) abcd1234 20 0
6 Connected (C) abcd1234 51 0 *
11 Active (A) abcd1234 10 0