Filter
Top Products
5-7
Cisco Wireless IP Phone 7920 Administration Guide for Cisco CallManager Release 3.3 or Later
OL-3930-02
Chapter 5 Configuring Network Settings on the Cisco Wireless IP Phone 7920
Verifying or Entering Network Settings
Modifying DHCP Settings
Dynamic Host Configuration Protocol (DHCP) automatically assigns IP
addresses to devices when you connect them to the network. If you do not use
DHCP in your network, then you must disable DHCP and manually enter network
configuration information. You can use the DHCP Enable/Disable menu, as
shown in Figure 5-3, on the phone to configure DHCP.
This section provides information about enabling and disabling DHCP in the
following topics:
• Enabling DHCP, page 5-8
• Disabling DHCP, page 5-8
• Configuring Static Settings, page 5-9
Figure 5-3 DHCP Menu Options
Network Config
DHCP
Enable/disable
Enable
Disable
IP Address
Subnet Mask
Primary
Gateway
Primary
TFTP Server
Primary
DNS Server
Secondary
DNS Server
Static Settings
Activate
85767