Filter
Top Products
Issue 2.0 December 1995 3-7
3. Enter the Routing Table using the information on Worksheet B that you
filled out following the instructions in Chapter 2, ‘‘Planning the Integration’’.
The Intuity system programming procedure is described in the ‘‘Entering
the Routing Table’’ section of Chapter 6, ‘‘Intuity System Administration’’ in
this book.
Administer MERLIN LEGEND System
for Cut-to-Service
At this time, the Intuity system is ready to process calls. The final administration
steps on the MERLIN LEGEND system route those calls through the voice ports
to the Intuity system. Perform the following steps to cut-to-service:
1. Use the MERLIN LEGEND system programming procedure described in
Chapter 5, ‘‘MERLIN LEGEND Switch Administration’’ in this book to add
the extensions of the remaining subscribers to the coverage group. The
coverage group was defined on the Group Coverage form (Form 7c for
Release 3.0; Form 6d for Release 2.0) that you filled out following the
instructions in Chapter 2, ‘‘Planning the Integration’’ in this book.
NOTE:
The coverage group was connected to the integrated VMI calling
group as part of the acceptance test procedure.
2. Use the MERLIN LEGEND system programming procedure described in
Chapter 5, ‘‘MERLIN LEGEND Switch Administration’’ in this book to direct
incoming calls on specified trunks to the calling group(s). The calling
group was defined on the Group Calling form (Form 7d for Release 3.0;
Form 6e for Release 2.0) that you filled out following the instructions in
Chapter 2, ‘‘Planning the Integration’’ in this book.
The integration is now complete with the exception of networking.