Filter
Top Products
Issue 2.0 December 1995 3-3
2. Assign an integrated VMI calling group with linear hunt type, as defined on
the Group Calling form (Form 7d for Release 3.0; Form 6e for Release 2.0)
that you filled out following the instructions in Chapter 2, ‘‘Planning the
Integration’’ in this book. The MERLIN LEGEND system programming
procedure is described in Chapter 5, ‘‘MERLIN LEGEND Switch
Administration’’ in this book.
NOTE:
Do not assign the trunks to the integrated VMI calling group at this
time. Do not set the integrated VMI calling group as the receiver for
the coverage group at this time. The Intuity system is not set up to
handle the calls yet, and callers will not receive the correct service.
3. Assign the Tip/Ring voice ports to the integrated VMI calling group
defined on the Group Calling form (Form 7d for Release 3.0; Form 6e for
Release 2.0) that you filled out following the instructions in Chapter 2,
‘‘Planning the Integration’’ in this book. The MERLIN LEGEND system
programming procedure is described in Chapter 5, ‘‘MERLIN LEGEND
Switch Administration’’ in this book.
Intuity System Initial Administration
Before the Intuity system and the MERLIN LEGEND system can communicate,
you must perform basic initial administration on the Intuity system.
NOTE:
These procedures correspond to the following steps in Chapter 2 of the
appropriate
Intuity Installation Checklist
.
■ Administer the Intuity Switch Interface on Intuity — See Step 1.
■ Map Channels to Switch Extensions — See checklist. Use the
extension and service information on Worksheet
Channel
Information for Installation
that you filled out following the
instructions in Chapter 2, ‘‘Planning the Integration’’ in this book.
■ Verify Channel State — See checklist.
■ Assign Service to Channels for Testing — See checklist.
■ Test Each Channel — See checklist.
■ Assign Services to Called Numbers — See Step 2.
■ Map Services to Channels for Operation — See Step 3.
■ Administer Intuity AUDIX Parameters and Basic Features — See
Step 4.