Filter
Top Products
Chapter 25: Enterprise VoIP Network Management
AltiWare ACM 5.1 Administration Manual 343
Changing the Server ID Length
The Server ID is used for the following two purposes:
• Identifying member systems in the VoIP domain
• Mapping to a remote system's IP address in the IP dialing table for system-to-system
dialing
Depending on the number of systems that will be added to the VoIP domain and the
number of entries in the IP dialing table, the Server ID Length can be set to 1, 2, or 3
digits.
Caution! The Server ID Length can be changed. However, if this number is changed,
the server IDs are all altered. If you increase the length, the number 0 is added
to the front of the server IDs. For example, if you change the length from 2 to
3, original ID 02 and 27 will become 002 and 027 respectively. If you change
the length from 3 to 2, the original IDs 112 and 311 will become 12 and 11. It
is advisable to keep the original length. If you are not sure about future
expansion, using a 3-digit length is advised.
Adding a Server to a VoIP Domain
Important: Before you add a server to the domain, you need to make sure that the
System ID (specified in AltiWare Administrator, System Configuration tab)
is not the same as another member server’s System ID. AltiEnterprise
Manager will use the System ID to build a unique identifier in the multisite
database. Once a server is joined to a domain, you cannot change the
System ID in AltiWare Administrator.
To add a server to a VoIP domain
1. Click the Add button in the Global Server Location panel to open the Add Server
dialog box:
2. Define the attributes for the server, and click OK:
Parameter Definition
Name Enter the name of the server.
Address Enter the IP address of the server.
Server ID A unique dialing number to connect to this server.