Filter
Top Products
Chapter 20: Paging Group Configuration
AltiWare ACM 5.1 Administration Manual 265
To add members to a Paging Group:
1. On the Group Member tab of the Paging Group Configuration window, select the
desired extension(s) in the Not Member list. Use Shift+click or Ctrl+click to select
several extensions from the list.
2. Click the Add button to move them to the Member list.
Figure 2. Paging Group Configuration, Group Member tab
When a member is added, its default state is Login. Paging group members can use #54
to perform group login or #56 to log off. If a member is logged off, then it will not receive
group paging.
To remove members assigned to a Paging Group:
1. On the Group Member tab of the Paging Group Configuration window, click the
extension(s) you want to remove in the Member list.
2. Click the Remove button to move them to the Not Member List.
Important:
• If an IP phone in a different network segment needs to be in a paging group, you
need to configure intermediate routers to pass through the IP multicast packets.
• IP paging to remote IP phones over WAN is not supported.