Filter
Top Products
4.2 CONNECTING THE KX-TVS50/80 WITH THE PANASONIC KX-TA624
68
INTEGRATING THE VPS WITH THE PANASONIC KX-TA ANALOG PBX AND KX-TD DIGITAL PBX
a)
If the KX-TVS50/80 is answering all incoming calls:
CO Mode
—Use System Programs [414](Day Mode), [415](Night Mode),
[416](Lunch Mode) to set this parameter. Program all lines DIL to the first extension
of the Voice Mail hunt group. The KX-TA624 will allow incoming CO calls to hunt
only if the CO lines are DIL to the first port of the hunt group. Lines programmed as
Normal do not hunt.
b)
If the KX-TVS50/80 is only answering calls not answered by the operator (Operator
Backup):
Flexible Ringing Assignment
—For each CO line, use System Programs [408](Day
mode), [409](Night Mode) and [410](Lunch Mode) to enable ringing at the
operator's extension(jack).
Delayed Ringing Assignment
— To give the operator time to answer the call before
the VPS picks up, we recommend setting the delay to 3 or 4 rings for each extension
connected to the KX-TVS50/80. Use System Programs [411](Day Mode),
[412](Night Mode) and [413](Lunch Mode).
CO Mode
— Set the mode for each CO to Normal. Use System Programs [414 ](Day
Mode), [415](Night Mode) and [416](Lunch Mode) to set this parameter.
c)
If the KX-TVS50/80 is only answering calls not answered by user extensions:
Flexible Ringing Assignment
— For each CO line, use System Programs [408](Day
Mode), [409](Night Mode) and [410](Lunch Mode) to enable ringing on every
extension (jack) that you want to have ring.
Delayed Ringing Assignment
— To give users time to answer the call before the
VPS picks up, we recommend setting the delay to 3 or 4 rings for each extension
connected to the KX-TVS50/80. Use System Programs [411](Day Mode),
[412](Night Mode) and [413](Lunch Mode).
CO Mode
— Set the mode for each CO to Normal. Use System Programs [414](Day
Mode), [415](Night Mode) and [416](Lunch Mode) to set this parameter.
6.
Unplug or power down the KX-TA624.
7.
Connect the jack(s) assigned in Step 3 to the KX-TVS50/80.
8.
Connect your laptop computer to the KX-TVS50/80 and start your communication software
(i.e., HyperTerminal, Procomm Plus, Smartcom...).
9.
Disconnect the power from the VPS and set the DIP switch to position 5.
Only perform this step when initially setting up the system.
Table 14 2 CO Lines, 2 Ports
CO Lines Ports
11, 2
21, 2