Filter
Top Products
7.2 UTILITY COMMANDS
148
SYSTEM MAINTENANCE AND TROUBLESHOOTING
7.2.18 Circuit Condition Display (LMON)
This command is used to display the circuit condition every 1.5 s. The command can be turned
off by entering [\].
The following circuit conditions may be displayed.
7.2.19 DTMF Information Display (PUTD)
This command is used to display the DTMF tones the VPS receives and sends.
In addition to the DTMF tones the following are displayed — the Incoming Call Service (Voice
Mail, Automated Attendant, Custom, and Interview) entered by the caller and the time periods
that the ports are enabled.
Type PUTD.
The VPS will remain in this mode until "PUTD" is entered again. The default
setting for this mode for all ports is "OFF."
To change the mode from "PUTD" to "OFF,"
Type PUTD
again.
To set the mode for only 1 port,
Type PUTD
and the port number.
"Ready"
"Incoming Call Service"
"Outgoing Call Service"
"DSP Reset Processing"
"PT connect Processing"
"Error/Not Exist"
: Possible to serve
: Processing arrival service
: Processing sending service
: Processing DSP reset disposition
: Processing PT connect disposition
: DSP Card is not loaded
$ LMON
CO No.:
1: Ready
2: Ready
Status
$ PUTD
Target Port : * *
$
$ PUTD
Target Port : 00
Don't leave enabled after troubleshooting
$
Note: "*" means "enable" for the port
"0" means "disable" for the port