Filter
Top Products
7.2 UTILITY COMMANDS
SYSTEM MAINTENANCE AND TROUBLESHOOTING
135
Type OFLN
, then
Press RETURN
. If no VPS ports are in use, the VPS will immediately
suspend the call progressing service.
If any VPS port is in use, the VPS will display the following warning:
The VPS will be in the Off-Line Mode when the following message is displayed.
7.2.2 On-line Set (ONLN)
The ONLN command is used to place the VPS in the Call Progressing Mode.
Type ONLN
, then
Press RETURN
.
7.2.3 Set Password (PASS)
The PASS command is used to create, change and clear system passwords. Valid passwords are
created using up to 8 characters; any alphanumeric character, [ (space)], [.] and [_] can be used.
1.
Type PASS
, then
Press RETURN.
2.
To create a password or change an existing password, go to Step 3.
To clear a password, go to Step 4.
3.
To create a password or change an existing password:
a) Type [1]
or
[2]
Note
When you press [2] to change the System Reset/Clear password you should
type the current (OLD) password before entering a new one.
b) Type
the password.
$ OFLN
** OFF LINE MODE **
*** Now line is used!! *** <WAIT>
** OFF LINE MODE **
$ ONLN
** ON LINE MODE **
$ PASS
1: Administrator Password 2: System Reset/Clear Password :=
Maximum 8 characters
NEW PASSWORD : =