Filter
Top Products
B6 SYSTEM ADMINISTRATION - SYSTEM PARAMETER SETTINGS
242
SYSTEM ADMINISTRATOR'S GUIDE
Table 60
Parameter Value Range
(Default)
Description/Function
Intercom
Paging
Sequence
Up to 12 digits con-
sisting of 0-9, , #
and special codes
(FXW)
Specifies the intercom paging sequence required by
the PBX. It can be programmed using up to 12 of the
following 8 letters and 12 dial codes.
D: Disconnecting
F: Hook Flash
R: Ringback Tone Detection
S: Silence Detection
T: Dial Tone Detection
W: Wait for 1 s
X: Pager Dialing
A: Answer
1-9, 0, , #: Dial Codes
Release for
Intercom
Paging
Up to 12 digits con-
sisting of 0-9, , #
and special codes
(F)
Specifies the intercom paging release code required by
the PBX. It can be programmed using up to 12 of the 8
letters and 12 dial codes as specified above.
No Answer
Time for
Intercom
Paging
1-30 s
(5)
When there is no answer, this parameter specifies the
length of time (in seconds) the VPS must wait before
concluding Intercom Paging.
The VPS will return to the caller if the paged party
does not respond before this timer expires.
Announcement
Repeat Cycle
1-3 times
(1)
Specifies the number of times the intercom page will
be announced.
Example:
"I have a call for (mailbox owner's name)."
Intercom
Paging Retry
1-10 times
(2)
Specifies the number of times paging will be retried
when the paging destination is busy or if there is no
answer.
Note
: This setting applies when the subscriber has set
only "Intercom Paging" status to enable in Incomplete
Call Handling Status.