Filter
Top Products
3.2 PBX PARAMETERS AND PORT SETTINGS
INTEGRATING THE VPS WITH PANASONIC KX-T PHONE SYSTEMS
49
Digit Translation Table Parameters
These parameters allow PBXs that have a fixed Follow-on ID sequence to be used with the KX-
TVS50/80. For example, a Follow-on ID sequence of [ 101] can be changed to [#6101]
by using these parameters.
•
Inter-Digit Time-Out:
This parameter defines the interval of incoming signals (Follow-
on ID) from the PBX to the VPS. The Digit Translation Table applies the digits received
within this time to translation.
•
Input-Output (up to 8 alphanumeric characters):
When the system receives digits
within the inter-digit time, it checks them against the input table. If they are found, the
system utilizes the output digits in their place.
7
Forwarded to Voice
Mail (Busy)
The extension dialed is forwarded to Voice Mail and no
other Voice Mail ports are available to accept the call. (This
signals the Voice Mail port [usually Auto-Attendant] to let
the caller to leave a message.)
8
Forwarded to Extn. The extension dialed is forwarded to another, non-Voice
Mail extension.
9
Confirmation Tone The Message Waiting Lamp On or Message Waiting Lamp
Off code is dialed successfully.
#9
Disconnect The caller disconnects. The central office must set a CPC
signal to the PBX line for this signal to work for CO calls.
Table 11
Code
(default)
Call State Sent to the Voice Mail Port When...
The Remainder of this section consists of step-by-step guides for software verification
and programming of the recommended Panasonic PBX systems.
If you have any problems as you go through this section, please call Panasonic Technical
Support at (201) 392-4843