Filter
Top Products
B6 SYSTEM ADMINISTRATION - SYSTEM PARAMETER SETTINGS
SYSTEM ADMINISTRATOR'S GUIDE
243
Other Parameters - Fax Management
The VPS can be programmed to automatically transfer incoming fax calls to a fax extension.
A maximum of 2 fax extensions can be specified as the destination for the Automatic Fax
Transfer. If the main fax extension is not available to receive a fax, the VPS will transfer the
fax transmission to the alternate fax extension.
Paging Code
for Group 1-8
Up to 12 digits
consisting of
0-9, ,# for each
group
(Group 1-8:
331-338
All Groups
(Group 9): 33 )
Specifies the intercom paging access code required by
the PBX.
Note
: The Intercom Paging Group Number available
for each Subscriber is determined on a COS-by-COS
basis.
Paging Code
for All Groups
To select Fax Management, follow the menu path as shown:
System Administration Top Menu - 1 - 5 - 7 - 8
Table 61
Parameter Value Range
(Default)
Description/Function
Automatic
Transfer of
Incoming Fax
Call
1: Disable
2: Enable
(Disable)
Used to enable or disable the Automatic Transfer of
Incoming Fax Call Service.
Note
: Automatic detection works for only the first 30s.
Main Fax
Extension No.
2-5 digits
(None)
Specifies the main fax extension number.
Alternate Fax
Extension No.
2-5 digits
(None)
Specifies the backup fax extension number used when the
main fax extension is busy or if there is no answer within
the specified "Fax No Answer Time." When either of
these situations occurs, the VPS transfers the fax call to
the backup extension.
Table 60
Parameter Value Range
(Default)
Description/Function