Filter
Top Products
B7 SYSTEM ADMINISTRATION - HARDWARE SETTINGS
SYSTEM ADMINISTRATOR'S GUIDE
251
To program the following 10 Parameters on the following page, use the Special Commands and
Dial Codes listed below. Up to 12 digits can be set for each parameter.
D: Disconnecting
F: Hook Flash
R: Ringback Tone Detection
S: Silence Detection
T: Dial Tone Detection
W: Wait for 1 s
X: Extension dialing
A: Answer
1-9, 0, , #: Dial Codes
Table 68
Parameter Value Range
(Default)
Description/Function
Operator
Transfer
Sequence
(FX)
This sequence is performed by the VPS when transferring
calls to the operator's extension.
Extension
Transfer
Sequence
(FX)
This sequence is performed by the VPS when transferring
calls to any extension except the operator's.
Alternate
Extension
Transfer
Sequence
(FX)
This sequence is performed by the VPS when transferring
calls to extensions in the Alternate Extension Group.
Reconnect
Sequence on
Busy
(F)
If an extension is busy, this sequence allows the VPS to
reconnect to the caller.
Reconnect
Sequence on
No Answer
(F)
If the extension does not answer, this sequence allows the
VPS to reconnect with the caller.
Reconnect
Sequence on
Refuse Call
(F)
This sequence is performed by the VPS to retrieve a call
placed on hold after the extension (in the Call Screening
mode) has refused to accept it.
Light-On
Sequence for
Message
Waiting Lamp
(None)
The dialing sequence that the VPS must perform to enable
the Message Waiting Lamp at an extension.
Light-Off
Sequence for
Message
Waiting Lamp
(None)
This is the dialing sequence that the VPS must perform to
disable the Message Waiting Lamp at an extension.