Filter
Top Products
4.2 System Programming
CPC Detection for Outgoing Calls
421
System Programming 4-79
Description Enables or disables CPC Signal Detection during an outside call in
progress. If enabled, the system disconnects the line at the time set
in program [420] “Calling Party Control (CPC) Signal” when the
CPC signal is detected.
Selection • Outside (CO) line number: 1 – 6, ( = all outside (CO) lines)
• Enable (detect) / Disable (will not detect)
Default Disable
Programming 1. Enter 421.
Display: CPC Out Detect
2. Press NEXT.
Display: CO NO? →
3. Enter an outside (CO) line number.
Pressing NEXT also can enter outside (CO) line number 1.
Display example: CO 1:Disable
4. Keep pressing SELECT until the desired selection is
displayed.
5. Press STORE.
6. To program another outside (CO) line, press NEXT or
PREV, or SELECT and enter the desired outside (CO) line
number.
7. Repeat steps 4 through 6.
8. Press END.
Condition • To assign all outside (CO) lines to the same selection, press the key
in step 3. In this case, the display will show: CO : Mixed.
Feature Reference Section 3, Features
Calling Party Control (CPC) Signal Detection