Filter
Top Products
Features 3-57
3 Features D
DSS (Direct Station Selection) buttons: Used to access
extensions, change the time (day/night/lunch) service, and set and
cancel the Remote Station Lock Control feature. Each button is
programmed to correspond to an extension. Pressing a button
allows the user to call the corresponding extension. Each button
also has an indicator (Busy Lamp Field), which shows the current
state of the corresponding extension as shown in the Table below.
To meet the user’s various needs, DSS buttons can be changed to
the other feature buttons.
PF (Programmable Feature) buttons marked as F1 through
F16: These buttons have no default settings. The paired telephone
user can program the buttons for other feature buttons.
Conditions • Programming the DSS and PF buttons can be done only from the paired
telephone using station programming.
• If the extension number assigned to a DSS button is changed to another
number, the DSS button automatically changes to the new number. (Re-
programming is not necessary.)
• Indicating the FWD/DND status of corresponding extensions using a
DSS button indication is programmable.
Connection Reference
Section 2, Installation
2.3.4 Extension Connection
Programming References
Section 4, System Programming
[003] DSS Console Port Assignment
[004] Paired Telephone Assignment for DSS Console
[112] DSS Console Indication Mode
Station Programming RRRRRRRRRR User Manual
Flexible Button Assignment
DSS Console Features RRRRRRRRRR User Manual
Station Programming
Feature References Section 3, Features
Button, Flexible Remote Station Lock Control
One-Touch Transfer Using Time (Day/Night/Lunch) Service
a DSS Button
Operation Reference DSS Console Features
— User Manual
Light
Off
On
Flashing*
State of extension
Idle
Busy
FWD/DND is enabled.
Busy Lamp Field Table
*: When program [112] is
assigned to “Enable”,
the indicator will flash.