Filter
Top Products
4-48 System Programming
4.2 System Programming
Call Duration Count Start Time
204
Description Sets the number of seconds the system waits between the end of
dialing and the start of the SMDR timer for outgoing toll calls.
When the system has sent all the digits to the central office and this
timer expires, the system will start counting the call. A display
telephone shows the elapsed time of the call. The starting time and
the duration of a call are recorded in the SMDR record.
Selection Instantly / 5 s / 10 s / 15 s / 20 s / 25 s / 30 s / 35 s / 40 s / 45 s /
50 s after dial (seconds)
Default 10 s after dial
Programming 1. Enter 204.
Display: Durat-Time Count
2. Press NEXT.
Display example: 5s after dial
3. Keep pressing SELECT until the desired selection is
displayed.
4. Press STORE.
5. Press END.
Condition • The timer starts counting after all the digits are dialed. This timer does
not apply to incoming calls. The timer for incoming calls starts
immediately.
Feature References Section 3, Features
Display, Call Information
Station Message Detail Recording (SMDR)