Filter
Top Products
4.1.1 Using Proprietary Telephones
4-4 System Programming
Viewing the Display
The display gives the user helpful information, such as the next
step, previous entries, etc.
The KX-T7130 and the KX-T7030 both utilize one information line
for programming.
The display capacity is 16 digits. If the entry is longer than
16 digits, the user can shift the display by pressing the
or
button.
Before entering the programming mode
Before entering the programming mode, confirm that:
• The telephone is on-hook.
• No calls are on hold at your telephone.
Entering the programming mode
1. Set the MEMORY switch on the telephone to
“PROGRAM”.
The display shows:
PITS-PGM NO? →
2. Dial #.
The display shows: Password :
3. Enter the system password (default 1234).
The display shows the initial system programming
message: SYS-PGM NO? →
Note • The entered system password is not shown on the display. The system
password can be changed by system programming. Refer to Section 4.2
[002] “System Password”.
• During the programming mode, the extension is treated as a busy
extension.