Filter
Top Products
4.1.2 Programming Methods
System Programming 4-5
Advancing to the next stage
When “SYS-PGM NO? →” is displayed, the user can go to the
desired program by entering the 3-digit program address.
Storing your data
Press STORE to store the data.
• The STORE indicator lights red and a confirmation tone is
heard.
* Confirmation tone (one beep)
After pressing STORE, a beep will be heard. This informs the user
that storing is completed.
* Confirmation tone (two beeps)
This informs the user that the same parameter has already been
stored.
* Alarm tone (three beeps)
If this alarm is heard, the user’s entry is not valid.
Making another selection within the same program address
• To make the next selection, press NEXT.
• To make the previous selection, press PREV.
• To make a specific selection, press SELECT and then enter the
number.
Confirming the entries
The user may review the stored programming without making any
changes.
Going to another program address
Press END and the initial system programming message will be
displayed.
The display shows: PITS-PGM NO? →
Then enter a program address.
You can go to the higher number program address by pressing the
button and the lower number by pressing the button while
the program title is displayed.
Display example: Date/Time Set
program title
Returning to the operation mode
Set the MEMORY switch to “SET”.