Filter
Top Products
Configuring the Voice Settings
Regional
Cisco SPA232D Administration Guide 83
4
Second Dial Tone Alternative to the Dial Tone when the user dials a three-
way call.
Default setting: 420@-5,520@-5;10(*/0/1+2)
Outside Dial Tone Alternative to the Dial Tone. It prompts the user to enter an
external phone number, as opposed to an internal
extension. It is triggered by a comma character
encountered in the dial plan.
Default setting: 420@-4;10(*/0/1)
Prompt Tone Prompts the user to enter a call forwarding phone number.
Default setting: 520@-5,620@-5;10(*/0/1+2)
Busy Tone Played when a 486 RSC is received for an outbound call.
Default setting: 480@-5,620@-5;10(.5/.5/1+2)
Reorder Tone Played when an outbound call has failed, or after the far
end hangs up during an established call. Reorder Tone is
played automatically when Dial Tone or any of its
alternatives times out.
Default setting: 480@-5,620@-5;10(.25/.25/1+2)
Off Hook Warning
To n e
Played when the caller has not properly placed the
handset on the cradle. Off Hook Warning Tone is played
when the Reorder Tone times out.
Default setting: 480@-3,620@3;10(.125/.125/1+2)
Ring Back Tone Played during an outbound call when the far end is ringing.
Default setting: 440@-5,480@-5;*(2/4/1+2)
Ring Back 2 Tone Your ATA plays this ringback tone instead of Ring Back
Tone if the called party replies with a SIP 182 response
without SDP to its outbound INVITE request.
Default setting: the same as Ring Back Tone, except the
cadence is 1s on and 1s off.
Default setting: 440@-5,480@-5;*(1/1/1+2)
Confirm Tone Brief tone to notify the user that the last input value has
been accepted.
Default setting: 600@-4;1(.25/.25/1)
Field Description