Filter
Top Products
Configuring the Voice Settings
System
Cisco SPA232D Administration Guide 60
4
DECT Handset 1 ~ DECT Handset 10 Status
System
Use the Voice > System page to configure general voice system settings and to
enable logging by using a syslog server. (Logging also can be configured in the
Administration > Logging pages. For more information, see Logging, page187.)
To open this page: Click Voice on the menu bar, and then click System in the
navigation tree. Enter the settings as described below. After making changes, click
Submit to save your settings, or click Cancel to redisplay the page with the saved
settings.
Requirements for Logging
• You need a computer that is on the same subnetwork as the ATA, to capture
the log files. This computer needs to be running a syslog daemon. Enter the
IP address of this computer in the Syslog Server and Debug Server fields.
Call 1 and 2
Decode Latency
The number of milliseconds for decoder latency.
Call 1 and 2 Jitter The number of milliseconds for receiver jitter
Call 1 and 2 Round
Trip Delay
The number of milliseconds for delay.
Call 1 and 2
Packets Lost
The number of packets lost.
Call 1 and 2 Packet
Error
The number of invalid packets received.
Call 1 and 2
Mapped RTP Port
The port mapped for Real Time Protocol traffic for Call 1/2.
Field Description
Handset IPEI The unique hardware identifier of the unit, comparable to a
MAC address.
Model Number The Cisco model number of the unit.
Field Description