Filter
Top Products
Configuring the Voice Settings
User 1
Cisco SPA232D Administration Guide 147
4
User 1
Use the Voice > User 1 page to set the user preferences for the calls through the
PHONE port1 .
To open this page: Click Voice on the menu bar, and then click User 1 in the
navigation tree. Enter the settings as described below. After making changes, click
Submit to save your settings, or click Cancel to redisplay the page with the saved
settings.
Call Forward Settings
PSTN To SPA Gain dB of digital gain (or attenuation if negative) to be applied
to the signal sent from the PSTN side to the ATA. The
range is -15 to 12.
Default setting: 0
Ring Validation
Time
The minimum signal duration required by the Gateway for
recognition as a ring signal.
Default setting: 256 ms
Ring Indication
Delay
Choose from {0, 512, 768, 1024, 1280, 1536, 1792} (ms).
Default setting: 512ms
Ring Timeout Choose from {0, 128, 256, 384, 512, 640, 768, 896, 1024,
1152, 1280, 1408, 1536, 1664, 1792, 1920} (ms).
Default setting: 640 ms
Ring Threshold Choose from {13.5–16.5, 19.35–2.65, 40.5–49.5} (Vrms).
Default setting: 13.5-16.5 Vrms
Line-In-Use
Voltage
The voltage threshold at which the ATA assumes the
PSTN is in use by another handset sharing the same line
(and will declare PSTN gateway service not available to
incoming VoIP callers).
Default setting: 30
Field Description
Field Description
Cfwd All Dest Forward number for Call Forward All Service.
Default setting: blank