Filter
Top Products
Configuring the Voice Settings
DECT Line 1 - DECT Line 10
Cisco SPA232D Administration Guide 160
4
Restrict Source IP If Lines 1 and 2 use the same SIP Port value and the
Restrict Source IP feature is enabled, the proxy IP address
for Lines 1 and 2 is treated as an acceptable IP address for
both lines. To enable the Restrict Source IP feature, select
yes. Otherwise, select no. If configured, the ATA will drop
all packets sent to its SIP Ports originated from an
untrusted IP address. A source IP address is untrusted if it
does not match any of the IP addresses resolved from the
configured Proxy (or Outbound Proxy if Use Outbound
Proxy is yes)
Default setting: no
Referor Bye Delay Controls when the ATA sends BYE to terminate stale call
legs upon completion of call transfers. Multiple delay
settings (Referor, Refer Target, Referee, and Refer-To
Target) are configured on this screen. For the Referor Bye
Delay, enter the appropriate period of time in seconds.
Default setting: 4
Refer Target Bye
Delay
For the Refer Target Bye Delay, enter the appropriate
period of time in seconds.
Default setting: 0
Referee Bye Delay For the Referee Bye Delay, enter the appropriate period of
time in seconds.
Default setting: 0
Re fer-To Ta r g e t
Contact
To contact the refer-to target, select yes. Otherwise,
select no.
Default setting: no
Sticky 183 If this feature is enabled, the ATA ignores further 180 SIP
responses after receiving the first 183 SIP response for an
outbound INVITE. To enable this feature, select yes.
Otherwise, select no.
Default setting: no
Use Anonymous
With RPID
When set to yes, use "anonymous" in the SIP message.
Default setting: yes
Use Local Addr In
From
Use the local ATA IP address in the SIP FROM message.
Default setting: no
Field Description