Filter
Top Products
Configuring the Voice Settings
DECT Line 1 - DECT Line 10
Cisco SPA232D Administration Guide 167
4
Attn Transfer Serv Enable Attended Call Transfer Service. Three Way
Conference is required for Attended Transfer.
Default setting: yes
Unattn Transfer
Serv
Enable Unattended (Blind) Call Transfer Service.
Default setting: yes
MWI Serv Enable MWI Service. MWI is available only if a Voice Mail
Service is set-up in the deployment.
Default setting: yes
VMWI Serv Enable VMWI Service (FSK)
Default setting: yes
Speed Dial Serv Enable Speed Dial Service.
Default setting: yes
Secure Call Serv Secure Call Service. If this feature is enabled, a user can
make a secure call by entering an activation code (*18 by
default) before dialing the target number. Then audio
traffic in both directions is encrypted for the duration of
the call.
Default setting: yes
For more information about star code settings, see
Vertical Service Activation Codes, page 90. To enable
secure calling by default, without requiring a star code, set
the user’s Secure Call Setting to yes. See User 1,
page 147.
Referral Serv Enable Referral Service. See the Referral Services Codes
parameter For more information.
Default setting: yes
Feature Dial Serv Enable Feature Dial Service. See the Feature Dial Services
Codes parameter For more information.
Default setting: yes
Service
Announcement
Serv
Enable Service Announcement Service.
Default setting: no
Field Description