Filter
Top Products
Configuring the Voice Settings
DECT Line 1 - DECT Line 10
Cisco SPA232D Administration Guide 154
4
PSTN Ring Thru Line 1 Ring Settings
DECT Line 1 - DECT Line 10
Use the Voice > DECT Line 1~DECT Line 10 pages to configure the settings for
calls using Cisco SPA302D handsets.
To open this page: Click Voice on the menu bar, and then click DECT Line 1~10 in
the navigation tree. Enter the settings as described below. After making changes,
click Submit to save your settings, or click Cancel to redisplay the page with the
saved settings.
NOTE When a DECT line receives an incoming from a RU and if no handset is registered
to this line or all handsets attached to this line are turned off, the base responds to
the RU in 9 seconds with "486 Busy Here.”
General
Field Description
Default Ring The default ring to be used to ring through Line 1. Choose
from {1,2,3,4,5,6,7,8,Follow Line Cfg}. If Follow Line Cfg is
selected, the ring is determined by the distinctive ring
settings for Line 1. The ring patterns are configured on the
Voice > Regional page. For more information, see
Distinctive Ring Patterns, page 85.
Default setting: 2
Field Description
Line Enable To enable this line for service, select yes. Otherwise,
select no.
Default setting: yes