Filter
Top Products
Configuring the Voice Settings
PSTN User
Cisco SPA232D Administration Guide 152
4
PSTN User
Use the Voice > PSTN User page to set the user preferences for calls through the
LINE port.
To open this page: Click Voice on the menu bar, and then click PSTN in the
navigation tree. Enter the settings as described below. After making changes, click
Submit to save your settings, or click Cancel to redisplay the page with the saved
settings.
Cfwd Ring Splash
Len
Duration of ring splash when a call is forwarded (0 – 10.0s)
Default setting: 0
Cblk Ring Splash
Len
Duration of ring splash when a call is blocked (0 – 10.0s)
Default setting: 0
VMWI Ring Policy The parameter controls when a ring splash is played when
a the VM server sends a SIP NOTIFY message to the ATA
indicating the status of the subscriber’s mail box. Three
settings are available.
Default setting: New VM Available
• New VM Available: Ring as long as there new
voicemail messages.
• New VM Becomes Available: Ring at the point when
the first new voicemail message is received.
• New VM Arrives: Ring when the number of new
voicemail messages increases.
VMWI Ring Splash
Len
Duration of ring splash when new messages arrive before
the VMWI signal is applied (0 – 10.0s)
Default setting: 0
Ring On No New
VM
If enabled, the ATA plays a ring splash when the voicemail
server sends SIP NOTIFY message to the ATA indicating
that there are no more unread voice mails. Some
equipment requires a short ring to precede the FSK signal
to turn off VMWI lamp.
Default setting: no
Field Description