Filter
Top Products
Administration Settings
Management
Cisco SPA232D Administration Guide 184
5
SNMP
Use the Administration > Management > SNMP page to set up Simple Network
Management Protocol (SNMP) for the ATA.
SNMP is a network protocol that allows network administrators to manage,
monitor, and receive notifications of critical events as they occur on the network.
The ATA supports SNMPv2 and SNMPv3. It acts as an SNMP agent that replies to
SNMP commands from SNMP Network Management Systems. It supports the
standard SNMP get, next, and set commands. It also generates SNMP traps to
notify the SNMP manager when configured alarm conditions occur. Examples
include reboots, power cycles, and INTERNET (WAN) events.
To open this page: Click Administration in the menu bar, and then click
Management > SNMP in the navigation tree.
Enter the settings as described below. After making changes, click Submit to save
your settings, or click Cancel to redisplay the page with the saved settings.
Settings for SNMPv2
Field Description
Enabled, Disabled Click Enabled to enable this feature, or click Disabled to
disable it. The default setting is Disabled.
Trusted IP Choose Any to allow access from any IP address (not
recommended). Click Address to specify the IP address
and subnet mask of a single SNMP manager or trap
agent that can access the ATA through SNMP.
Get/Trap
Community
Enter a community string for authentication for SNMP
GET commands. The default value is public.
Set Community Enter a community string for authentication for SNMP
SET commands. The default value is private.