Filter
Top Products
Configuring the Voice Settings
Line1 Settings (PHONE Port)
Cisco SPA232D Administration Guide 106
4
Call Feature Settings
Field Description
Blind Attn-Xfer
Enable
Enables the ATA to perform an attended transfer operation
by ending the current call leg and performing a blind
transfer of the other call leg. If this feature is disabled, the
ATA performs an attended transfer operation by referring
the other call leg to the current call leg while maintaining
both call legs. To use this feature, select yes. Otherwise,
select no.
Default setting: no
MOH Server User ID or URL of the auto-answering streaming audio
server. When only a user ID is specified, the current or
outbound proxy is contacted. Music-on-hold is disabled if
the MOH Server is not specified.
Default setting: blank
Xfer When Hangup
Conf
Makes the ATA perform a transfer when a conference call
has ended. Select yes or no from the drop-down menu.
Default setting: yes
Conference Bridge
URL
The ATA supports external conference bridging for n-way
conference calls (n>2), instead of mixing audio locally. To
use this feature, set the parameter <Conference Bridge
URL> to a specific bridge URL in the server. For example:
conf@myserver.com:12345 or conf (which uses the
Proxy value as the domain).
For a 3-way conference, select "conference" from soft key
options on the handset or hookflash for FXS. For n>3, add
participants by making new calls.
Default setting: blank
To establish a conference bridge the ATA first sends
INVITE to the conference address and then REFER the two
calls to the same address. The conference server then
does external audio mix/relay on behalf of the 3 parties.